Our Colour Dare Challenge for #492 is the colours of the In Full Bloom Scrapbooking Workshop Kit in a tic-tac-toe grid - Black, White and Grey are Free to use. When you are creating for more than one challenge please make sure your project meets our requirement. Most importantly - have fun! Go to the link for Colour Dare #492 and add your entry. When you submit your entry you must provide a link to your post, not just to your blog in general. There are LOTS of ways to enter either a Blog Post or post to an online gallery (Facebook, Pinterest, SplitCoast Stampers, or Instagram).
![]() |
| RETIRED STAMP SET I also recently did some training with this style stamping as shown below. That was the inspiration for this weeks colour dare. |
![]() |
| RETIRED STAMP SET |
Part of this technique is to stamp over the edges which leaves a little bit right next to each layer blank. That is the purpose of filling with the Mink layers later.
I only used 3 vehicles because young boy was turning 3. Then put the non-stop fun stop sign in the corner.
Inside I wanted to do a pop up so I cut a bit of lagoon cardstock at 4 inches wide by just under 6 inches long (it was a scrap that fit so I didn't measure). I scored at each inch along the section and folded up in the middle and down on the sides... valley fold on the sides and mountain fold in the centre. Then I decided to stamp the presents on each side from the Cake Day—Scrapbooking Stamp + Thin Cuts. Note to self: Stamp on this part BEFORE folding... stamping on a folded piece is not easy!
I also used Cake Day—Scrapbooking Stamp + Thin Cuts to cut the cake in Lemonade cardstock and stamp in black ink. Then I cut one of the candles off (only 3 candles required). Then I decided to do a cake on both sides so did a second one and cut off a different candle on the reverse side.
I also added a dump truck in Sundance - fussy cut out.
The truck didn't really match but didn't look too bad and I cut the candles to show each side only having three candles.
On the below side I also stamped the "Hooray! Hooray!" stamp on there (prior to sticking the items). I made sure adhesive only on the bottom of the first side and on second side only to place it where the stamps are touching so no adhesive sticking out. If I made a mistake I could correct with Anti-static Pouch to remove stickiness.
![]() |



